Key Information at a Glance
-
The appearance of water on the door leaf is a result of the physics of air and temperature differences and usually indicates insufficient ventilation, not a lack of airtightness in the door itself.
-
Excess moisture leads to corrosion of mechanical components, can cause short circuits in the drive electronics, and promotes the growth of mould and fungi.
-
Through the use of ventilation grilles and sealing systems with controlled air infiltration, the door takes on an additional role in the building’s air exchange system, beyond its primary protective function.
-
In unheated garages, continuous ventilation is essential, whereas in heated garages, the ventilation function integrated into the drive system is the optimal solution.
-
The best results are achieved through a combination of door ventilation, an unobstructed gravity ventilation duct in the building, and the regular removal of water and snow brought in by the vehicle.
Condensation in the Garage – Why Does a Sectional Door “Cry”?
Water droplets on the inside of the door leaf worry many owners, who often suspect a lack of product tightness. However, the real cause lies in the physics of air.
As the largest external closure of the garage, the sectional door is particularly exposed to temperature differences.
The Physics of the Dew Point: Where Does the Moisture on the Inside of the Door Leaf Come From?
The key concept is the dew point, the temperature at which air can no longer hold water vapour in its gaseous state, causing it to condense into liquid water.
How the Process Works
When warm, humid air (for example, after parking a wet vehicle) comes into contact with the cold surface of the door panels, the boundary layer cools rapidly and condensation occurs.
Moisture Balance
After rain or snowfall, a vehicle may bring several litres of water into the garage in liquid or solid form. Without adequate air exchange, the relative humidity can quickly rise to 80–90%. If the temperature of the door leaf is only a few degrees below the ambient temperature, the door may immediately begin to “cry”, forming visible condensation.
Consequences of Poor Air Circulation – From Corrosion to Mould Growth
Persistent moisture in a garage is not just an aesthetic issue. The consequences of insufficient ventilation can be costly:
1. Moisture and Condensation
Moisture settles on torsion springs, guide tracks, and hinges. Even galvanised steel can oxidise under continuous condensation. High-quality galvanised steel also has its limits. With constant exposure to moisture, the zinc coating gradually deteriorates, leading to rust formation.
Corroded springs become brittle and are far more prone to sudden failure during operation, increasing the risk of door blockage. In addition, the increased friction caused by corroded rollers places the drive system under a greater load, shortening the service life of the entire operating system.
2. Damage to Electronics
Sectional door operators, typically mounted beneath the ceiling, operate in the area where the highest concentration of moisture accumulates. Moisture entering the housing condenses directly on circuit boards and electrical connectors. This creates unwanted conductive paths, which can lead to short circuits and control system failures.
3. Biological Hazards
Dark, damp corners of the garage, especially around bottom and side seals, provide ideal breeding grounds for moulds and fungi such as Cladosporium and Aspergillus.
This becomes particularly critical when the garage is integrated into the structure of the house. Fungal spores can easily enter living spaces through internal doors, contaminating indoor air and potentially causing allergic reactions and respiratory problems.
Nederlands
Polski
Österreich


